Welcome to the Lumibricks® User Guide

This guide provides technical information and installation instructions for Lumibricks lighting kits. It is intended to support correct installation, safe usage, and stable long-term performance.

About Lumibricks® Lighting Kit User Guide


⚠️ Safety Warnings

  • Use only with a power supply below 5V to prevent damage to LED components.
  • Not suitable for children under 6 years old.
  • Use tweezers when necessary to assist installation.
  • Test all lighting components before final installation.
  • LED components are fragile and should be handled with care during assembly.
Cable positioning example

🔌 Installation Instructions

  • Connect the lights to a power bank or battery box to verify functionality.
  • When installing wires, route them between studs instead of placing them directly beneath bricks.
  • For street lamp components, remove the side panel and route the wires through the internal space.
  • Store excess wires beneath bricks to prevent damage or disconnection.
  • LED ceiling lights are typically installed on the upper surfaces of bricks or within internal structures.
Wire routing Spare wire concealment Ceiling LED plate

🧩 Component Handling

  • LED Lights can be placed on or between Lego® studs.
  • Strip lights includes a self-adhesive backing for easy attachment to bricks.
  • Cables should be routed between studs to avoid pinching or tearing.
  • Connectors should be inserted gently and in the correct direction into strip lights and expansion boards to avoid damage.
LED between studs Strip light adhesive Cable routing Connector into strip Connector into board

🔧 Troubleshooting

  • Verify that batteries are correctly installed and the power source is active.
  • Ensure all cables are firmly connected to the corresponding LED components.
  • Inspect expansion board ports for bent pins or poor contact.
Battery check Expansion board check

⚠️ Important Notice

  • All LED components must be handled carefully to prevent breakage.
  • Do not apply excessive force when connecting plugs and connectors. Incorrect installation may result in damage or short circuit.
  • If short circuit is suspected, disconnect power immediately to prevent potential damage.